standard pressure
英 [ˈstændəd ˈpreʃə(r)]
美 [ˈstændərd ˈpreʃər]
网络 标准气压; 标准压力; 标准大气压; 標準壓力
英英释义
noun
- a unit of pressure: the pressure that will support a column of mercury 760 mm high at sea level and 0 degrees centigrade
双语例句
- Therefore, many countries have drawn up the corresponding standard in pressure vessel especially for the head to the shell cover processing quality.
因此，各国针对各行业中的压力容器尤其对封头的加工质量都制订了相应的标准。 - Under the assumption of the mathematical models of the pseudo steady state and unsteady state flow, and equation of meeting the needs of the standard pressure in coalbed gas may be obtained by use of the standard gas pressure to replace the pressure in Langmuir adsorption formula.
在拟稳态流和不稳态流的数学模型假设下，用气体标准压力代替Langmuir吸附公式中的压力，得到气层中标准压力所满足的方程。 - A critical temperature of water is 100 degrees C& its boiling point at standard atmospheric pressure; critical mass; go critical.
水的临界温度是摄氏100度&标准大气压下的沸点；临界物质；达到临界。 - With the comparable parameter, the equivalent leakage, the standard of pressure test of some gas lines at home and abroad has been analysised in this paper.
用各试压工况的当量漏气量这一可比参数，对国内、外几种煤气管道的试压标准做了分析。 - The computer controlled pressure measuring system is composed of a pressure scanning valve and a programmable standard pressure source controlled by a quartz pressure sensor.
计算机控制的压力测量实时校正系统由压力扫描阀，及石英压力传感器控制的可程控标准压力源等部份组成。在这种系统中，传感器的数量大大减少了。 - By converting test condition to the standard pressure condition, calculation accuracy of average pressure impulse coefficient method is superior to that of tangent method.
换算到标准压强条件下，平均压强冲量系数法的计算精度优于切线法的计算精度，并作出了计算验证。 - Discussion the self-calibrating method of standard pressure source
标准压力源自校准方法探讨 - Bulking number: American paper measurement of the number of sheets that bulk to1 inch in thickness under standard pressure.
厚度号数：美国量度一寸内有多少张纸的方法。是在标准压力下一寸厚的纸张页数。 - Status and Discussion about Application of Pipe Flange Standard in Pressure Vessels
管法兰标准在压力容器行业中的应用现状及探讨 - Up till now, in the defect assessment standard of pressure vessel, a semi-experience method, equivalent K ( stress intensity factor) conversion, usually used to deal with beried and surface three dimen-sional crack.
在压力容器缺陷评定标准中对埋藏和表面三维裂纹问题的处理，通常采用半经验的等应力强度因子（K）换算方法。